Easy Loom Scarf

Skill Level:

Finished Size:

Materials:

• Regular Knitting Loom
• 2 light weight packages of yarn
• Loom Hook
• Scissors
• Crochet Hook (Optional)

Gauge:


Abbreviations, Notes and Tips:

Instructions:

Pull the center ends of each ball of yarn and line them up.
Create slipknot and put on the anchor peg on the side or bottom of loom.

Initial Loom setup and knitting foundation


• Wrap the yarn in a figure eight pattern starting on the bottom row and wrapping up to the top peg and back down to the bottom peg. Continue this process until you reach the width you desire. Push the yarn to the bottom of the peg.
• Changing direction, when desired width is reached, continue to wrap a second row over the original pegs until two rows are complete.

2. Continue wrapping for two rows of wrap.



Using the loom hook


• Using your loom hook, take the bottom row and pull it up and over the top loop on each peg.
• After the first sets of loops have been pulled over, start the wrapping process again. This time only wrapping once so that each peg has 2 loops again.
  After a few rows have been completed, remove the original slipknot from the anchor peg.
  Continue wrapping and pulling over the bottom loops until you reach the desired length of your scarf.



Using the loom hook



Using the loom hook

• To cast off, each peg should have 1 loop per peg. Starting on the bottom peg, remove the loop using the loom hook.
  Remove the first loop by pulling it over the second loop.
  Repeat this process going from the bottom peg up to the top peg.
  Once to the last peg, slip everything through the loom and set the loom aside.
• Cut the working yarn leaving about an 8-inch tail. Using a crochet hook or the loom hook, weave the tail into the scarf.